Monster Manual Revisited: The Glabrezu!
Next up in my effort to update all my old models is this terrifying demon! He is a bit of a challenge for FDM with supports in the mouth, but it shouldn't be impossible if your settings are tight. For resin I've supplied the presupported files, though if you want to make your own I say tilt him back so his teeth don't need any and use thin supports.
Full files are in D - Demons. You can find them here too: https://www.prusaprinters.org/prints/37322-glabrezu-updated
Next up is the Goristro! He was updated last year but I figure I should make him more fuzzy. Take care friends :)
Comments (2)
Your models are very imaginative. It would be nice if they came in a higher textured version.
These are intended to be 3D printed, so adding more texture wouldn't show up in most cases. Remember the majority of my models are supposed to be a tall as your finger tip. In this case my thumb. If I throw in extra texture sure the render would be pretty but I'd end up wasting my time thus slowing my productivity. Sorry friend. I'll add more when it's logical.