Descent into Avernus: Warlord Bitter Breath!

My next effort in this book following the Infernal War Machines are the Warlords of the Avernian Wastlands! First up is Bitter Breath the outcast devil who leads his horde of misfits, outcasts, and hobgoblins! 

He should print fine as is so long as you use supports. I recommend tilting him back about 45 degrees so his horns are pointed up and aren't too dependent on supports except for the bottom.  For resin, even if though he's a large creature thin supports are still the way to go as well as tilting him back about 20 degrees. 

Full files are in the Baldurs Gate: Descent into Avernus folder. You can find the free stl here too:  https://www.shapeways.com/product/NTS5GH34H/bitter-breath  

Next up is Feonor the Archmage! That parasol is going be a challenge but I'll figure it out :-)