Drow Arachnomancer printed and painted!

A special thanks goes to Jen for priming and prepping this guy for painting :-). Given this was a resin print obviously I recommend printing him on tilted on his back at about 45 degrees with thin supports. Amazingly the sword came out just fine. FDM wise I'd print him as is and make sure your support game is on point, as that hilt can be a challenge, but not impossible. You could also size him up too. 

But anyway, the full files are in the MTOF folder under Drow. You can get the stl here too:  https://www.shapeways.com/product/DL4A72JWW/drow-arachnomancer  

Onto the Drow Favored Consort!