Moloch printed and painted!
Here is the infamous Archdevil from Mordenkainen's Tome of Foes now ready to terrorize my players :-D . A special thanks to Jen for removing the supports for me <3
Full files are in the MTOF folder under Devils- Archdevils. You cand find the stl here too: https://bit.ly/2QiLRO1
Next up is Titivilus!
Comments (10)
How do you generate supports for the photon? I have him at 45 degrees with auto supports from the Photon Slicer but it generates a lot of them.
Yup I had a forest of supports. Nothing you can do about it :-/
Did you print it on your Anycubic? If Yes: Did you hollow the modell?
Yes Anycubic. No I didn't hollow. Probably should have haha
So i wasn't paying attention and ordered orange PLA this week lol. I still think it looks ok. If i print him again i will probably do it without the raft, i had a hard time getting the whip to come off. https://imgur.com/9m4MSGv
Nice!!!
Did you use a wash? What color?
Yup! Citadel Nuln Oil :-)
This is great Miguel!!! Really awesome!! 👏👏👏
Thanks!