New Requests Completed!

Hello friends! Today I worked on a variety of requests and made:

• Leshy - this is the adorable Pathfinder version that was a real treat to work on today. Its just so cute! AAAHHHHH! But anyway its a rather small creature so if you do print this in FDM use organic supports and be careful removing them around the leaves. For resin users the usual presupported file is up. I added extra mass under each of the leaves so they should be more sturdy when you remove supports. Full files are here and in the Pathfinder & Starfinder folder.

• Tiefling Male Barbarian 3 - this was a simple remix project that was a nice mix of sculpting and modeling. Same printing tips as above. Files are here and in Adventurers - Barbarians - Tiefling Barbarians.

• Elf Male Fey Hexblade Warlock 2 - another simple remix project. Same printing tips as above but make sure you angle the fingers upward. Files are here and in Adventures - Warlocks - Elf Warlocks.

My take on the Leshy uses trademarks and/or copyrights owned by Paizo Inc., used under Paizo's Community Use Policy (paizo.com/communityuse). I am expressly prohibited from charging you to use or access this content. My take on the Leshy is not published, endorsed, or specifically approved by Paizo. For more information about Paizo Inc. and Paizo products, visit paizo.com.

More to come tomorrow! Enjoy!