Saruman LIGHT UP Staff ready for downlaod :)

Something I’ve always wanted to make… Saruman’s Staff!
But not just Saruman’s staff — this one is a remotely controlled, LIGHT-UP version :)

The coolest part? The electronics I used are the same ones I’ve included in some of my previous projects, so chances are you already have everything you need to get started.

Assembly preview (press fit strip version) here
https://www.youtube.com/shorts/15NDY41Rd5Y

Download here (We Are Makers) — Youngling members will get an email soon:
https://www.patreon.com/posts/117444806

_______

This release includes 3 versions of the staff:

1. With a cutout for a rod (for structural strength)

2. With a cutout for press-fit strips (instead of a rod, you print “strips” that connect the staff — note: depending on your infill & wall count, it can be a bit wobbly. I may add a thicker version later based on your feedback!)

3. Fully combined (so you can cut it however you prefer and use your own rods)

And there are 3 "gem" versions:
1. Fully combined with drain hole (for resin, non-functional, no lights)
2. Split in the middle (for an LED light source)
3. Split on the lower end (for an LED light source)

So you can build it whichever way works best for you!

This was also a little test run for another project I have in mind… but more on that later.
Hope you have fun with this one — can’t wait to see your builds! :)