GCODE 02⏐ PART 09 ⏐ Rhino and Grasshopper

PRINT SETTINGS

Below you'll find my print settings for most of my prints when using PLA. You will want to change this in these cases:

• If you use a material that's not PLA, the temperatures and print speed have to be adjusted following the table.

• If you use a nozzle that's not 0.8 mm you will have to change the layer height and layer width. You can use the recommended values.

As a quick tip, if you ever feel like the print quality could be improved, you can safely drop your layer height down to 0.5 or 0.45 millimeters (using a 0.8 mm nozzle).

Also, you can find the grasshopper surface modifier featured in the video very soon, in the resources collection as well as in side the Series 02 collection.