mz4250

Today I created a commission piece and an Ancient Dragon Tier reward that I'll print and paint soon. First for the commission I have a homebrew insectoid monster called an Elasarian, located in the E folder and here: https://www.prusaprinters.org/prints/36177-elasarian I also made a new Fire Sorcere

Today I created another fairy folk per a patron commission. She's a fresh model, though the wings were from the original fairy queen not to long ago. What's interesting about this one is that its a small creature, but thankfully in FDM all of her main features still show up. Full files are in both d

Hello again friends. Here is a new model I made today via the Dragon God commission tier. Its nice to add another Dragonborn to the mix, but a ranged one is a nice change of pace too. To print him he should be fine as is with supports given how thick I made the bow and arrow. However printing him on

Here is a different take on the Drider Queen per a Commissioned Model request! She's Huge sized but amazingly fits in the Photon if you wanted her in resin haha. FDM is the intended print though, and supports would be needed under her crowned horns with a roof and floors. Given how large she is thou

Here is my next commission for this month! This demon is MASSIVE standing roughly 10 inches tall. I actually had to make a new colossal sized stand for him. You have also the option to print his chain with and axe separately for easier printing. Full files are in the C folder in both drives. You can

Here is a Commission model that I made this morning. Its a bit of remixing of my older model that needed some serious tuning up. Its labeled Dwarf Wizard 2 in both Google Drives and attached below. You may need to download each file individually. Onto the next challenge!

This evening I'll be working on another commission model! The target: A Giant Wasp that can actually have a miniature stand on it like a mount! I've never made mounts like this before so it should be a fun exercise. Plus the original Giant Wasp I made is rather tough to print so it'll be good to mak

For todays stream I made my first commission model of the month, a cool Angel of Knowledge. You can find him in the A - Angels folder. He's rather massive and his feathers are made of sheets of paper so I recommend printing him on his back with supports. Another option is to remove the base in Blend

Hello again friends! Thank you for tuning in today as I 3D modeled more minis for you all! Today I actually modeled some commission work which includes a Lillend Paladin, located in Adventurers - Paladins folder in the Google Drive. I also modeled a Warrior Goddess Avatar, located in the W folder. T

Hello friends. Tomorrow at 8am EST on Twitch ( mz4250 - Twitch ) I'm going to 3D model my first commission pieces! Tomorrow expect: Female Winged Snake Warrior Warrior Goddess And if I have time I'm going to make another CR character for fun. I'll give Nott a try :-) I hope to see you then!