Tome of Beasts: The Orobas Devil!

Hello friends! Today I made the next devil from Tome of Beasts! This equine headed fiend is known to be quite wise, deceitful, and commanding of lesser devils. This was a good sculpting and rigging project. I particularly enjoyed sculpting the chain shirt texture, though I'm afraid that'll only show up on newer resin printers. I made two poses, one with a flail and another with a spear. The flail is obviously very thick in comparison to real ones but that's so its actually printable. 

Both poses are a bit of a challenge to pull off in FDM however if you angle the flails and spears so that supports aren't needed in most of them it should print ok. For resin users the usual presupported file is up.

More to come tomorrow! Enjoy!