Skabatha Nightshade of the Hourglass Coven is ready!
Hello friends! Today I proudly present to you all the third member of the Hourglass Coven, Skabatha Nightshade! This was a lot of fun to model and sculpt. I'm curious if the rocking horse will rock well haha. I made sure to also make a file of just the rocking horse by itself in case someone uses it as their own sweet mount. Full files are in the Wild Beyond the Witchlight folder. You can find the free files attached to this post too.
My take on Skabatha Nightshade and the Flying Rocking Horse are unofficial Fan Content permitted under the Fan Content Policy. Not approved/endorsed by Wizards. Portions of the materials used are property of Wizards of the Coast. ©Wizards of the Coast LLC.
More to come tomorrow! Enjoy!
Comments (4)
I had no issue with the supports on an anycubic mono 4k. But did have the same issue where she usually topples backwards instead of rocking or standing up but she does have a very small sweet spot where she will stand. All in all an amazing build though and my PCs meet her this Sunday so perfect timing too. Thanks!
Got her printed, and the balance is way back. Also, the left rocker failed behind the horse leg (Pre-supported), and the balance point is behind that, so it won't stand. I'll print it again (i'll try cura supports this time) and hollow the skirt, and see if it will balance. But, loving the Witchlight so far!
Are you going to be making one of just her without the horse?
No sorry. But the blender files are here and you are welcome to remix her as you need to :)