Santa's Sleigh Pulled by Owlbears!
Hello friends! Well it took a lot of work but Santa's Sleigh Pulled by Owlbears is ready! The sleigh is large enough to hold up to four PCs if you want to make this the parties ride during a holiday one shot. There are five owlbear variants in this post each with a harness and rings wide enough for you to tie your own string / yarn / hobby story chains to the sleigh which has its own rings.
The Owlbears were oriented so they can be printed easily in FDM. Presupported files were included too for resin users. Full files are located in Misc Patron Requests - S .
Ok that's all for now! More requests to come tomorrow! Enjoy!
Comments (10)
They drain poorly, sadly - was quite an issue while painting
In the pre-supported files, I see the holes in the feet but I don't see one on the bottom near the supports, will these print without an issue from the suction/force?
They should print fine given the angle they're in allowing drainage.
Out of curiousity, what figures do you have in the sleigh?
I honestly don't remember lol
AMAZING 👏
This is amazing! Makes me want to put out the printer and get to work... lol though I waiting for face to face gaming to start back up before more printing... Great set of figures!
This is "Out-Freaking-standing"! Thank you.
This has to be the best holiday themed sculpt i have seen in a long time. Thank you for sharing your awesome skills!!! 🐉
:)