Monster Manual Revisited: The Roper!
Hello friends! Today I present an updated Roper! I made sure to make a hollowed and presupported file for resin users while for FDM you can print him as is so long as your support settings are tweaked. The overhangs aren't too bad so it should be fine even in the mouth.
Full files are in Monster Manual - R - Roper.
Next up is the Rust Monster! Stay tuned!
Comments (4)
Hey there Could you upload your standart base for humanoid minis as a single print ? because currently all my printed minis are from your page but i´d also like to print a few from other sources while keeping the base size and shape consistent
The size markers are located the the folder 1 basics.
It might be good to have a couple more versions of this for FDM printers. One with the tentacles separated and one with the tentacles pointing straight up. They're really hard to support. When I printed the prior version, I somewhat deliberately under-supported the tentacles and just let them fail, and then rebuilt them by hand using a pen extruder. A vertical version would allow the user to bend them to their liking using a heat gun.
The original was made in this format. You can use that and it'll look fine in FDM.