Last Submission of 2020: Request Board models!

Hello again friends. Here are two more models from the Request Board I was able to complete. We have: 

Gnome Male Bard with Bagpipes - for FDM I recommend printing him at a 45 degree angle so the supports won't be needed for the pipes too much. You can also try on his back if you have your settings tweaked out. I've uploaded a presupported file for resin users. Full files are in Adventurers - Bards

Female Commoner - making her gave me an opportunity to reorganize the commoner folder, given its getting a little full. She should print "ok" with no supports in FDM as is, but I'd still use them just in case, and preferably on her back or at a 45 degree angle. For resin I've uploaded the presupported as usual. Files are in Appendix B - Commoners. 

Thanks Again Everyone!

Tomorrow is New Years so I'm going to take some time off. However looking back at 2020 I gotta say its been a hell of a run. First year self employed, but, during a pandemic.  It certainly had its challenges that's for sure. Jen and I pulled though, though the losses along the way were not easy. 

Thanks again everyone for being so supportive. 2021 will be a busy one that's for sure. Expect more Rime of the Frostmaiden models, more updated Monster Manual creatures, and of course, the unique requests from you all. I will however keep an eye out for any burn out risks and take time to myself within reason. Take care and keep being amazing :)