Monster Manual Revisted: The Dragon Turtle!
Looks like a missed a dragon last month lol. This big fella has been split up into pieces for easier FDM printing but in theory he could be printed as one piece if you're printer is big enough. I also made hollowed and presupported pieces for resin users too,
I had some fun and also made a version of him popping out of water. I'm not really very good at liquid effects so you're paint job will have to make the base look more like water. Not hard with some good dry brushing obviously.
Full files are in D - Dragon Turtle. You can find them here too: https://www.prusaprinters.org/prints/47935-dragon-turtle-updated
Next up is the Driders!
Comments (7)
Will do. Thank you :)
question about hallowed minis. I tried printing the front of this (starting this morning at 5am) and getting home at about 7:30pm from work and only like 30% printed cause I ran out of resin. Turns out its very much solid lol. Anything I have to do to get it hollow?
It's hollowed on my slicer. If it doesn't show up hollowed on your end I'm not sure why that's the case. I recommend going to the sla channel on the discord to see if anyone has that same issue.
Loving the Season of Dragons! Can’t wait for the Half-Year of Dragons! and then... :p
It’s Dieter!
Eh dragon turtles aren't technically dragons. Kinda like pseudodragons. Depending on the setting and the source of course.
In 5e they're listed as dragons. But meh it's all good.