Ice Troll.stl 5.1 MB

Ice Troll.blend 10.8 MB

Ice Troll presupported.stl 99.6 MB

Snow Golem.blend 998.1 KB

Snow Golem sculpted.blend 25.9 MB

Snow Golem.stl 19.2 MB

Snow Golem presupported.stl 36.4 MB

Brain in a Jar.blend 935.1 KB

Brain in a Jar presupported.stl 20.9 MB

Brain in a Jar.stl 15.1 MB

Brain in a Jar sculpted.blend 22.5 MB

Brain in Jar top presupported.stl 5.9 MB

Brain in Jar bottom.stl 12.0 MB

Brain in Jar bottom presuppported.stl 18.2 MB

Brain presupported.stl 3.7 MB

Brain.stl 1.9 MB

Brain in Jar top.stl 29.0 MB

October 27, 2020

3d printing 3d modeling 3dprinting 3dart 3dModeling D&D DND dungeons & dragons Dungeons and Dragons Rime of the Frostmaiden constructs Undead

More Rime of the Frostmaiden Models!

Today I created more minis based off the amazing book ROTF! I made:

Snow Golem - This creepy fella has been oriented for optimal printing with FDM printers and supports. I also loaded up a pressupported model too.

Brain in a Jar - along with an FDM friendly version that's just the jar itself, I also split it up into pieces for resin users if they want to literally make a functional container out of it so you can float the little brain mini.

Ice Troll - This wasn't too hard to pull off given I had a base Troll model already from the Monster Manual. Threw on some fur and he was good to go! Sadly the model is too complex for my usual Shapeways upload so I attached the stl here.

My takes on the Snow Golem, Brain in a jar, and Ice Troll are unofficial Fan Content permitted under the Fan Content Policy. Not approved/endorsed by Wizards. Portions of the materials used are property of Wizards of the Coast. ©Wizards of the Coast LLC.

Anyway that's all for now. I'll make more request board models tomorrow. Take care folks :)

Comments (1)

PhaKing DM · October 27, 2020

Awesome! The Ice Troll will work great as a "Scrag" for Rise of Tiamat