Descent into Avernus: Haruman

This morning for some reason I woke up at 4am. I figured "Well I'm up. Might as well be productive" so here is Haruman from Descent into Avernus ready for printing. 

For resin he should print fine tilted back about 15 degrees with thin supports. For FDM I recommend printing him on his back so most of the front details come out fine. Obviously use supports. You can also try as is though you might lose some spikes. 

Full files are in the Baldur's Gate: Descent into Avernus folder. You can find the stl here too: 

 https://www.shapeways.com/product/ULREUFMYG/haruman 

I'm going to close my eyes for a little to get a recharge then get back to it. Take care folks :)