Monster Manual Revisited: The Werewolf!

This month one of the Tier Reward requests I got was to update my old werewolf model. The original was a Skyrim model I found five years ago that I remixed for printing. It did the job but obviously it wasn't mine, and very low detail. So its nice to finally make one with the details brought up a notch :)

I figured out how to use Prusa Slicer to position minis as flat as needed for proper FDM printing. So this stl is already flat and ready to go. You can obviously reposition it as needed for resin and what not. 

Full files are in the L - Lycanthrope folder. You can find them here too:  https://www.prusaprinters.org/prints/31249-werewolf-updated  

I'm going to model more requests tomorrow at 0830 EST on  Twitch . I hope to see you there!