Sorrowsworn - The Lonely, now printed and painted!

Ok so this fella is not easy. Like.. at all. I opted to just print the body and use an old FDM printed stand for it. I ran out of see through glue so for now it will stay lose until I get a vile haha. 

Whether FDM or resin, be sure to print this guy on his back. For resin see if you can elevate it off the ground some and use at least one heavy support. I printed him flat on the base and that led to a build up of support material that was hard to remove. 

Full files are in the MTOF folder under Sorrowsworn. You can find the files below as well.

Onto the next challenge!