Request Board Model: Lizardfolk Fighter!

Christmas break is going well. Woke up early before the rest of the family so I knocked out a Request Board model. I hope to make many more when I can, but again, its family time so my output might be lower than usual. 

Here is a scimitar wielding Lizardfolk fighter ready for action!  In resin he should print fine titled back about 20 degrees. In FDM I recommend printing him on his back. You might lose some spikes but the rest will come out ok. You can also try as is, but your support game must be strong. 

You can find this in the Adventurers - Fighters - Other Fighters folder in both drives or attached below.

Time to get breakfast. Take care everyone!