Updated Goblin in melee!
You asked for it so I made it happen! Here is my goblin, now updated! This should print fine in FDM as is if your support game is on point, but I recommend printing him on his back. In resin you should angle him at a 45 degree angle on his back with thin supports.
In the Share Drives you'll find him in G - Goblins. The old goblin files are still there but are now in a OLD Goblins folder haha.
Files here too: https://www.thingiverse.com/thing:3463399
Next up is a Ranged Version and many other minion types that need a serious tune up :-D
Comments (2)
mz4250 is King ! Great designer and also nice if you print on a FDM printer, like i do.
And 1 question: 'Goblin_melee_new' has an issue; around layer 280-290 one of the supports gets knocked over. (just when the middle spike in his shield is nearly finished. always same hight. What to do ? FDM-printer Bambu Labs P1S, esun pla+, model upright, supports: tiny tree, gap's 0.3, branch diam.: 1 mm instead of standard (2mm), temp. 210. (These settings are ok for much more other models.)