The Soulmonger is ready!
The Soulmonger from TOA is ready for 3D Printing! Its been split up into pieces so you can print it FDM. Use a hot hair dryer on the tentacles after you glue them into the top portion.
The files are in the TOA folder in the Share Drive. You can also grab it below. Enjoy!
Comments (6)
Any suggestions on printing the tentacles? Supports? Brim? Just wondering what these are going to come out like.
Print them flat with brim and supports. Then run then under a hot hair dryer to warp them however you want.
To anyone printing this, according to the board I've made of this, which is as close to scale as I could do, you need two struts at about 5" and one at about 3.5". Otherwise, they go way beyond where they should. I plan to just cut mine down. Scaling in Cura makes the bases thinner, but you can probably adjust them with the blend files or in meshmixer maybe. Can't wait to get it all painted. Thanks again Miguel.
I'm printing them full size so we'll see how it goes haha
Thanks. I was the one that asked about this on FB. This will be much better than the popsicle sticks and plastic bottle I was working with, and just in time.
Noice :-)