The Tri-Flower Frond from Tomb of Annihilation!
So this model was pretty easy to pull off in resin, but I have a feeling it'd be a real challenge in FDM. I recommend maybe sizing it up, or using minimal supports given its such a light body.
Full files are in the TOA folder in the Share Drive if you want to make adjustments. You can get the stl here too:
Onto Volo!
Comments (4)
Curious what kind of supports you recommend when printing with PLA. I generally use zig zag but they can be tough remove and my first tri-flower didn't survive.
I usually use line. They are easier to remove and still do the job. In Cura anyway.
I managed to print 3 of them yesterday with .25 nozzle size. When removing the support the stems broke off on two of the three, but they were easy to glue back on again. I recommend starting with the support in the top of the model with the flowers and moving down.
Nice! Glad to hear it!