November 24, 2018
Brain Collector!
Ok first creature from the poll is up! Its in the B folder in the Share Drive but also below:
Onto the Wereturkey!
Comments (8)
R
Richard Fife · December 18, 2018
Any printing advice for an FDM? The space between the base and belly need supports to print it "flat", but not sure what the best angle of attack might be. (Tried twice and the legs were all sorts of fiddly for me, too.)
m
mz4250 · December 18, 2018
Be sure supports are everywhere and print slow. Say 30mm. And make the supports thicker than usual. They'll be harder to remove but the print will be stable. I say still print as is.
D
Douglas Rector · November 25, 2018
That looks like it should be in a 50's sci fi B movie - Love it!
m
mz4250 · November 26, 2018
Thank you!
J
Joe Johnston · November 25, 2018
Which book is that from?
m
mz4250 · November 25, 2018
No idea lol
W
Walter K · November 24, 2018
It's horrifyingly beautiful
m
mz4250 · November 24, 2018
Thanks!