Orc Archer!
One of my Adult Dragons is getting this in the mail soon :-D
Comments (3)
My nephew liked this for his backup character for his first D&D campaign. Good timing!
I have a question about this. One of my players is wanting the female alchemist, however I seem to have issues with the bow when printing. If I print it standing up it's too brittle and snaps, how do you position yours for print? tried to lay it on it's cloak side however ran into issue of my supports not coming off clean and making cloak look bleh, *though this could have easily been my fault in my slicer settings, still tweaking
This was a resin print so the supports we're very easy to remove. I would use meshmixer to create your own supports and have them only under his left arm and under his cloak. You don't need supports for the arrow and bow given their current angle as is