Starfinder and Pathfinder Dragons!
Hello friends! Today I worked on more requests from the Request Board! I made:
Void Dragon from Starfinder - this is my first Starfinder model! I went ahead and named my Pathfinder folder in the drives "Pathfinder & Starfinder" until more models are made for either genres. Its a pretty standard dragon when it comes to printing though. The pieces are split up and oriented for easier FDM printing. For resin printing I recommend printing it in pieces too though you're welcome to try to print the full sized one. Modeling it was a pretty chill experience. Dragons are kind of second nature to me now haha.
Water Linnorm from Pathfinder - the serpentine dragons from Pathfinder sure are a lot of fun to make! I made a version sloshing around in water but if you wanted a regular underwater one the model is rigged up for you to have fun with. For FDM printing you can print the body as is, and you'd get the best results on the head by printing it side ways. For resin printing same tips as above. Full files are here and in Pathfinder & Starfinder - Linnorms.
My takes on the Void Dragon and Water Linnorm uses trademarks and/or copyrights owned by Paizo Inc., used under Paizo's Community Use Policy (paizo.com/communityuse). I am expressly prohibited from charging you to use or access this content. My takes on the Void Dragon and Water Linnorm is not published, endorsed, or specifically approved by Paizo. For more information about Paizo Inc. and Paizo products, visit paizo.com.
That's all for now! Sept was a pretty busy month! But onto the next month and all the fun challenges that come with it. Hmm.... its spooky month. Hmmm