New File Alert! P1P Jedi Holocron Enclosure Frame

Good afternoon cool cats and kittens.

Today we have a bit of a weird project!

With the major explosion of interest in the BambuLabs printers (and pestering by my good friend Taylor) I decided to work on a frame that snaps right onto the P1P!

It uses a combination of tight snaps and tolerances along with holes modelled into the panels in specific points that line up with the frame of the printer.

With some small hardware (I tested with 4-40 screws) and gluing the panels together right and square, the panels actually slide on and secure quite well.

I highly recommend assembling the side panels in full with some light glue to assist with the initial securement to the printer.

Once this has been tested for fit, I would remove the panel, prime and paint for the final step.

All of the holocron details will have extremely tight fits so some sanding may be required around the detail pieces.

This will be a bit of a work in progress as while I am happy with the fit, I look forward to feedback from you all to make the assembly even smoother.

As always, thank you for your support

Kevin

Dungeons & Starships