New File Alert! First Order TIE Pilot armor and sidearm

Good Afternoon, good evening or good morning!

I am very proud to release the Final Cut of the First Order TIE Pilot armor including a rebundle of the SE-44C Blaster pistol for those of you who did not get this on previous months.

The armor is designed in several pieces with the helmet being split up to remove all the details.

The helmet is quite large as it’s default scaled to my large noggin at 24-25” so I would recommend using print rings to test the size. There is plenty of room inside for fans.

Also included is a visor buck if you choose to vac form or use this for the perfect bubbled lenses.

The base chest and back plates are left in solid pieces so they can be scaled to fit your body before being sliced for better consistency.

These files are designed around the 501st CRL for the pilot which helps for proper assembly.

The chest should be velcroed to the back plate as it fits directly over top, with the chest boxes to be attached separately to keep a good curve with the chest plate.

The chest boxes are designed to fit a 1.25” hose from the box to the aerator on the helmet.

I recommend using a small elastic snap on the underside of the top of the shoulder bell to connect it to the collar and elastic with parachute clips to be glued to the lower part of the bell to keep it snug.

The bracers come in a solid piece as they should be better fit to your arm this way but can be split for a piano hinge or elastic strap closure.

The belt boxes are just simple rectangles and squares but can easily be velcroed to your belt to give you that complete look!

On top of this, the SE-44c is separated into several pieces for easy printing.

As always, thank you so much for all your support. I can’t wait to see what comes out next. ;)

This model was created by Danny.g.3d. Check him out on Instagram!

Kevin

Dungeons & Starships