[Archived] CUTE RUSTIC BIRDHOUSE

🔗 [Archived] Release
This design has now been archived on Patreon and is available on MyMiniFactory and Cults3d.

Everything is printed easily and without supports!

The dimensions of the feeder are quite small and will easily fit on a 225mm table
The parts need to be glued

-Entrance for small birds
- diameter of entrance: 34mm 37mm
-Make a layer of 0.25mm or 0.3mm so as not to waste much time

Be sure to have your bridge settings at "ON".
Watch for over extrusion.

If there are problems with the assembly, write to id_myron on Instagram

The assembly steps are contained in a zip folder