(Oct23 Rewards) Skullified Deadpool Helmet + Skull!
Hey guys here is our latest Skullified Helmet= Deadpool!! Not only did we make a wearable version, but we made a skull of it too that you can use as a prop or to decorate your house with!!!
Features:
- Has multiple eye mesh variants
- Sized to 23" Head size
- Holds 8x2mm magnets
- Cut up to make it easier to print on smaller printers
Hope you all enjoy this mask and skull! We have more on the way!!! Stay tune!
Yosh
Comments (24)
where the link?
can you please send be the link to the file?
Where can i find the links??
Mitch, will you be fixing the back piece ? About to go to paint but will hold off if a new backplate is being done.
i was not able to assemble this, the back and front pieces do not fit together my front piece broke when trying to force it together. both are at 100 percent
the Eye_R has an artifact on it. when i load it there is this small something in the file. the build volume on the right eye is much bigger than the left
Best way to print the rings?
Question - are all of the rings the same? Or do I need to remember which ring goes in which slot?
There’s a front version and back version of the rings. You can print a bunch of each and it should be fine
Please keep them at 24" head size so us with big noggins can wear them easy ;)
i need a xl bambu
i cant print fast enough
Another banger!
Oh man! Firing this up asap!
Love to hear it!
You are the man!!!!!
🔥 🔥
🔥🔥
Sweet thanks brother
I literally just joined after finding you guys a few moments ago. How do I access these files?
Welcome to the club! Check your inbox
This is insane 😍😍😍😍..have the folders for October been sent out I need to get started on this print asap
Just sent to you!
😶🌫️