July 16, 2021
Pre Support Poll
Guys a lot of people have been saying that the rafts on the pre-supported files give them problems, lets figure this out so I know if we should do flat presupports or raft presupports for future. :)!
Comments (4)
J
Jesse P · July 16, 2021
Rafts with the 45 degree edge
I
Iron3eagle · July 16, 2021
I found that depending on room temp I sometimes need to increase the bottom layer exposure time. I seem to have an easier time removing rafts.
M
Mike Davies · July 16, 2021
@Realm Gate Studio makes a good point. Flats with a 45 degree bevel/slope is a good idea. I just started experimenting with this on the models I am supporting.
V
Voxtide Studio · July 16, 2021
When I do my supports for other patreons, I use flats with a slope of 45 so the scraper still pops them off easily. Also lowers tension on the fep by not having a huge raft pulling.