3D Printing my own $2,500 Airless Basketball... sorta
This video was way too much fun. Also, note to self, when you buy a new wireless mic make sure to test it for more than 5 minutes before jumping into a video recording. I didnt realize it was so bad. Will be futzing with that later today after I clean up all of the broken basketball bits
I'd definitely recommend printing one of these in a Flexible PLA or that Super PLA from overture. So much fun
Comments (5)
Try some Shore 60D filament, it is a lot firmer than the Shore A stuff.
Wondering if PA or PA-CF would increase Bounce and durability?
nice work as always, any time frame on sharing the n4m max profiles you talked about in your last few posts like .32 or the petg???
The only thing holding me back from printing one was waiting for you to make a video about it. I think I'll need some more filament. Thanks for the rundown!
I have to get started on mine