March 2026 Release: the Wrath of Marduk!
The Wrath of Marduk
A new set of Sons of Marduk miniatures has arrived this March 2026 to mark the end of the development of this fantasy race, full of incredible miniatures!
For this final set of miniatures you will receive new heroes for the Sons of Marduk, including three new Marduk Commanders, one new Sorcerer mounted and on foot and the incredible Great Sorcerer of Marduk mounted on Lamassu.
As it has been heavily requested by the community, we have also updated our previous Marduk Bull to include an alternative body with a saddle. Now you will be able to mount the Marduk Bull with a Sorcerer.
You will also receive an additional set of Hobgoblin miniatures, perfectly designed to support your expanding Hobgoblin fantasy race!
The March 2026 set of miniatures is composed by:
For the Hobgbolins:
1xHobgoblin War Elephant
4x Hobgoblin War Elephant Crew
1x Hobgoblin Ballista
2x Hobgoblin Ballista Crew
1x Hobgoblin Chariot
3x Hobogblin Chariot Crew
6x Hobgoblin Spearmen
1x Hobgoblin Hero mounted on wolf
For the Sons of Marduk:
1x Great Sorcerer of Marduk on Lamassu
1x Marduk Lamassu
1x Sorcerer of Marduk on foot and mounted
1x Update: Marduk Bull with saddle
1x Marduk Commander 1
1x Marduk Commander 2
1x Marduk Commander 3
Comments (9)
Amazing work!
I hate to ask this because I genuinely think this months releases have been the best you've done since I was a patreon of yours, but is there any chance of a re-work to make the tassles on the howdah top separate like they are on the bottom of the elephant blanket? 5 hours of printing can be easily wasted if just one snaps off whilst removing the supports, and although you can argue i should be more careful it then has to survive post once I have sent it out to my customers. If separate I can even print a few extra spares for people in case of accidents at home.
Hi Kevin! In fact, we would like to make some modifications to the howda as of today it can only be printed at 100% scale in big printers, as it doesn't fit smaller printers. That requires to split the piece in half somehow. We are still trying to figure it out and eventually we will update it, including the separation of the tassles, that also requires some new geometry as the current one doesn't allow separation -no surface to create clean cuts and pins- like the one in the elephant body. Unfortunately we may have to way a couple of months -probably in late May or early June- as we are going to be quite busy these next couple of months!
These are wonderful Thank you. Already getting to work on supporting and slicing, however can I check something regarding the Lamassu. There is only the left wing in the unsupported STLS. Is this because a mirror will do or is the right one missing?
Thank you for the kind words Kevin! Regarding your question, we updated the files this morning to include also the right wing to avoid confusion, but yes, only a mirror is required to obtain the right wing from the left wing as they are the same geometry, only on opposite sides! :)
Wow! You guys have outdone yourselves with that elephant.
Thank you for the support!!
What a wonderful final!!!!!! Need to warm up my printer after winter to start printing a full new army! Can’t wait for it!!
Thank you for the support Alexis, glad you like the miniatures!