Flexi-Halloween-Bat (September Design) (Archived)
Hello Everyone!
I am super excited to share this Articulated Flexi Bat that flaps its wings with the help of a rubber band. It hangs from a wire through its twisted feet and can stand on its feet and tail with a bit of balancing.
Please use the 'Rubber-Band-Insert' STL file to pass the rubber band through the holes on the back side of the wings. Alternatively, you can use some wire to insert the rubber band through the holes.
As usual, I have prepared a pre-painted file as well as a stacked version that is downscaled to 75%. Please do not downscale any further! Please avoid brittle filaments, especially on the downscaled version.
Rubber Band used, Below are some links
https://amzn.eu/d/0hy6YWx
https://amzn.eu/d/iesiszh
Suggested settings:
Support free design
Layer height: 0.18mm
Wall count: 3
Bottom: 4
Top: 5
Use the outer brim for better layer adhesion
Infills 15%
Happy 3D printing!
----------------------MMF Link-------------------------------
Comments (7)
This is so cute! Sad I missed the Parasaurolophus. Will it be available for purchase?
Thank you :) The Parasaurolophus is now available at MMF mmf.io/o/318130
going on the printer.
So friggin Cute!
Thank you, Love to see your printed results
Eeek.... that's so cute
Thank you🥰 May I expect a share of printed results on social media 😎