The Flexi Bamboo Dragon is Here!🐉

Hey Everyone!

The wait is finally over — the Flexi Bamboo Dragon has finally arrived! 🐉🌿

This one kept me busy for a few extra days because I worked on every single dragon scale to make sure the details really pop even after printing. I hope you enjoy printing and playing with this little dragon as much as I enjoyed designing it!

One important thing to mention: if you find the wing joints are a little too tight, you can use a small amount of heat to help adjust the fit and snap the wings onto the body. I’ve tried my best to optimize the tolerance, but I kept the wing joints slightly tighter intentionally. If they are too loose, the wings can become floppy and won’t hold their position properly.

I highly recommend doing a single-color test print first, especially for the wings, so you can check the fit before starting a multicolor print and avoid wasting time and filament.

Hope you all love the Bamboo Dragon! 🐉❤️

Print Settings

• Supports: Not Required

• Layer Height: 0.16–0.18 mm

• Walls: 2

• Top Pattern: Concentric

• Infill: 15% Gyroid

• Scale: 100% to 80%

All other settings can remain at their default values.

Happy Printing!✨