Venom Bust *New Release*

Greetings friends and i wish you all to have a great month

I know its been a week since the month started and i'm a little late than usual, but for a good cause :) I have been sculpting the Venom figure all week and we are now in testing phase. So i thought while you wait to cut the bust so you have something fresh to print. 

So here he is!

As you can see in the image i chose to make the upper teeth separate because it would be hell to use supports inside the mouth. Luckily this choice was a very good one because now the teeth are very easy to print for both FDM and resin, and also i just place them inside without glue. Of course depending on the printer it might need a drop of glue to stay there.

The only place in the model that needs supports is the tongue and everything else will print just fine.

So what do you guys think? I hope you like it and i cant wait to see your prints :)

Right now i split the figure in parts for FDM printing and for much larger resin prints. The first resin test results are very promising and have a beautiful result.

Here are the first two resin prints from my beta testers Joe Casa and Charro Zuck.

So that's it for today. Stay tuned for the release of the Venom figure that will probably happen tomorrow if everything goes as planned with the testing.

As always thank you all for your amazing support.

Fotis