New Thermoform: Baseball Candy Holder

https://makerworld.com/en/models/3386485-thermoformed-baseball-candy-holder#profileId-3853865

New thermoform is up — a baseball. This one's a small extra aside from today's Christmas ornament, so consider it a bonus drop.

It prints flat as a white mesh disc with red stitching, then you heat it and press it down over the included mold and it comes out as a round ball. Big enough to fill with candy or a small gift, and everything inside shows through the mesh. There's a cap on top so you can hang it, and a small tab that keeps it closed when it's just sitting on a shelf.

After the football, a baseball felt like the obvious next one. The stitching was the part I kept going back and forth on — those red lines have to survive being stretched over the mold without smearing into the mesh, and this version holds up well.

The 3MF is in the files here, with the mold and push block already on the plate. White with red stitching is the classic combo, but team colors would look great too.

Thanks as always for the support — it's what keeps these coming. If you print one, send me a picture ⚾