Top Secret Information

👋 Hey friends!

📚 This post includes everything important in one place:
✅ Downloads
✅ Switch info
✅ Print settings
✅ A few extra tips that might save you some frustration later

⏬ DOWNLOADS

📦 WELCOME PACK – See what’s included in your starter pack LINK.
🗓️ CURRENT MONTH (November) – Fresh new designs waiting for you
📁 PREVIOUS MONTH (October) – Missed last month’s files? They’re right here.
📁 VERY PREVIOUS MONTH (September) – Last few hours to download this month’s designs.

ℹ️ INFO

🔘 SWITCH INFO & WHERE TO BUY – Full assembly guide, recommended links, and everything you need for perfect clicks.
💸 MEMBERS’ DISCOUNT CODE – Get 50% OFF on older archived designs.

⚙️ PRINT SETTINGS

• Nozzle: 0.4 mm
• Layer Height: 0.2 mm
• Outer Wall Width: 0.4 mm
• Wall Generator: Aracne (Face-down orientation)
• Walls: 3
• Infill: 10–15% (Gyroid or Adaptive Cubic)

💡 Pro tip:
My keycaps are designed for a tight fit — they snap onto the switch stem without glue.
If it’s too tight, lower your filament flow ratio (around 0.92 works well, depending on filament color/brand).
If it’s too loose, increase the flow slightly.

🎨 FILAMENT

Any brand of PLA filament will work for you..
Colors used are listed in each design post.

🧠 Remember: these designs look good, click great, and usually make someone else say:

“Hey, can you print one for me too?” 😉