Septembers Filament Color Guides are Here!🐶🎃
Hey everyone!
Attached are the Filament Color Guides for both our Welcome Pack and our upcoming September Release!
As always, we aim to release these Guides 10–14 days ahead of the Models so you have plenty of time to order any specific Filament colors you may need and have everything ready to go when Release Day arrives!
Make sure to use the code 'NOSTALGIC3D' at checkout to receive 15% off your entire order!
>>>LINK<<<
Remember, all Full Models now come with Split Options! We hope these Guides make planning your prints a little easier and help you get the exact look you're going for.
As always, Happy Printing!
— Nostalgic 3D Models
Comments (9)
Trying to use your code as well, trying to buy 40 rolls of the panchroma and it doesn't take the code.
Try again now. Reached out to the rep and it was because we were running a promo on our Starlight's and CoPE, so you likely had one or both of these products in their cart which where auto adds
Panchroma™ Basic PLA with Chase and Marshall colors 11 in total
Hey there just tried to place a order on polymaker with some "Panchroma™ Basic PLA" and there is an error "NOSTALGIC3D discount code isn’t valid for the items in your cart" not sure why
Have you already used the code previously?
Hello! Just wanted to ask if older models are going to have retro split options?
eventually
Do you know the amount of filament for the life size PP ?
all depends on which model and infill. For ours we did it with 5% infill and average about 2,000g