St Patrick's Day Little Knitted Elephant

This might just be my favourite knitted elephant so far 🥰

• Features •
☘️ Print in Parts, only 4 parts, separated by colour and 1 colour change for the hat
☘️ Parts slot together. No glue required, but glue for extra stability.
☘️ Both AMS and Non-AMS Friendly, to suit everyone's requirements. If you prefer to use filament rather than paint pens, then the eyes and nose are selectable within the STL so you can change them independently from the body.
☘️ Approximately 8cm x 4cm (can be scaled up)

• Print details •
- Labeled .3MF file, making it easy to print the parts you need.
- All STLs provided
- Tested with layer height 0.12 for less noticeable and smoother layer lines.
- Tiny amount of supports on the cover.
- Parts slot together, no glue required, but glue for extra stability.

• For AMS Users •
- Within the STLs parts are easy to select and use the fill paint tool, (1 click).
- If you prefer to use filament rather than paint pens for any of the small details like the eyes, and eye brows, then use my 1 click guide to colour the features Fill Colour guide (click here)

• For Non-AMS Users •
- Large parts are separated by colour on each plate.
- There are 2 colour changes for the Hat. Start with green filament, then pause at (Layer 27 Switch to black Trim), then (Layer 94 switch filament to Green)

• Alternative Options •
- You can also print in a single colour and use an alicyclic paint pen. A guide can be found in my "A Guide to Acrylic Paint Pens" (click here)

⭐Any issues or support, please message me ⭐