New functional print: modular filament stand

Hey everyone!

I’ve just finished a new functional project – a modular filament stand for standard spools.

It’s fully printed, assembled and loaded with filament here, so it’s a “real life tested” design, not just a render 😄

Some quick specs:

• 14 standard 1 kg spools per level

• 25 mm chrome furniture tubes (I used 1 m long ones, usually under 2 USD each)

• Smallest version uses 4 tubes and has 2 levels

• 2-level stand needs 20 × M8x20 Allen screws (including feet and top endings)

• Each extra level adds 8 more screws

• Minimum print bed size: 250 × 250 mm

• Printed in PET-G, but ABS/ASA also works great

Important tip:

Print one connector part first and test it with your tube – every printer has slightly different tolerances. The tubes should be a snug fit, and the screws only lock them firmly in place.

Files are available on my MakerWorld profile: TomczukCustoms.

If your filament pile is getting a bit out of control, this stand might help a lot 😅

Thanks for your support – more functional prints and cute characters are already in progress! 💚