Knitted Early Access #3 (August 2024)

This is a cute knitted Seahorse same as your grandma would have knitted for you.

This needs no supports to print. No assembly needed after print.

Make sure to upload a make after printing.

Thank You!

Printed with 0.2 mm layer height.

10% Infill.

No Supports

Comments (4)

Tiffany Shamaly · August 14, 2024

I’m am really struggling on this one. I do reduce the size to 60% but out of eight individual ones I’ve only gotten one to complete. They spin out and I’ve actually had a few thrown off the plate. Any suggestions?

Utsav Genesis · August 14, 2024

Try better adhesion or use raft to print.

Andi Patsky · August 12, 2024

very cute

Utsav Genesis · August 12, 2024

Thanks a lot!