New File Alert! Anakin Skywalker’s Lightsaber (ROTS)
Good afternoon everyone!
I am very happy to release the newest lightsaber to the collection, this time a classic in Anakin Skywalker’s lightsaber from Revenge of the Sith.
This lightsaber is designed to use the same core and hardware as the rest of the Sabers, a TXQSaber core which is secured with 2x 4-40x 1/2” screws.
its currently designed for a pressure fit saber blade, but a small hole can be drilled in the emitter for a blade retention screw.
Happy holidays to everyone and we will be starting the giveaway on January 1st! Stay tuned!
As always, thanks for the support!
Kevin
Dungeons & Starships
Comments (7)
What about the 'new' TXQSaber cores which have only the on/off button and some USB-C charging connector not right below the power button? Since I looked at a lot of TXQSaber cores only the older ones have the (non USB-C) power plug where the holes are in the 3D files.
I haven’t used one of those so I don’t have any designs specific to that. I would have to get my hands on a core to design around it
Since the new big resin printers I won't go back to fdm ;) I already have working parts made out of ABS like resin :)
I’m very excited to see the outcome! Definitely better to print
Became a member for that and also ordered a TXQSaver (v4). I guess I would also need some ABS or Nylon Resin, too, what's best?
Hey! Depends on how rough you want to be on it. Resin printing tends to be a little tough but definitely go with an ABS like resin. I tested all of my sabers with fdm printing specifically.
LETS GOOOO