New File Alert! M7S Suppressed SMG : Halo ODST

Hey everyone! 

I'm sure most of you have seen the WIP posts related to this but I've finally got all of the pieces test printed and fit properly. 

Almost all of the small detail pieces should fit on a larger scale resin printer to make that sanding a little bit easier.

The stock has several different slots for the pin system I have rigged up. This way you can change the sizing for easy travel or to just make it a bit easier to carry.

If using the smaller separated pieces, it's designed for a 7", 1/2" dowel in the middle. Otherwise, It's quite sturdy without the need for much structural support.

The foregrip uses an M5 bolt to help it be able to rotate along the lower piece and a cutout has been made for the red dot sight that is meant to be printed in transparent resin.

Thanks so much for all of your support this month.

PS, I'm happy to announce I will be attending DragonCon in August and will be bringing an ODST kit (hence all the Halo models) If you will be in attendance, say hi!

Kevin