JINX TEST PRINT!!!
Hello again dear patrons, this is Jinx's test print, I took the suggestions of curving the braid to make the figure more compact and take up less space, which I thought was great.
I hope you like it and be sure that the prints will turn out well.
🎆3D PRINTER: Anycubic mono X
🎆RESIN: Anycubic Eco UV Resin Gray (first time using it)
🎆SIZE OF THE PRINTED FIGURE:
220 mm high
100mm long
115mm deep
Jinx 170mm
Regards!!!
Comments (3)
I see the base print file has holes on the side (3 holes), is this normal, since I dont see it in the test print?
Hi Werner. Those three holes correspond to resin drainage holes and to facilitate washing. When it is printing, it comes off by suction, so I chose to put those spaces on it to avoid that and save on resin consumption.
Are we gonna see vi next?