On to the primer! Sky-gea Build: Part 26
In this episode we focus on the rear overfender and get the first layer of primer on in preparation for mould making.
Timestamps:
00:00 - Intro
00:12 - Removing the old sideskirt pieces
03:11 - Fitting new sideskirt piece
10:34 - Refining door gap
16:39 - Trimming door handle
17:57 - Sanding sideskirt
19:30 - Troubleshooting 3D printer issues
19:58 - Filling low spots
22:18 - Sanding and primer prep
23:33 - Masking
24:33 - First pass of primer
27:43 - Thank you to my Patrons
28:13 - Block sanding primer
33:13 - Reshaping rear fender
34:41 - Adding bolt holes
40:24 - Filling bolt holes
41:43 - Adding bolt holes again
43:39 - Second pass of primer
45:04 - End product
45:26 - Outro
Comments (3)
The results look so good!
This is some zen content as always. Exciting to see progress, looks like getting that printer dialed in is working like a charm for you. And the side to side skirt symmetry! 🧑🍳👌
Cheers bro. I was actually really surprised by how good that sideskirt piece came out just from the print itself. If I had my belts tensioned properly I could have eliminated the need for filler.